Industrial water treatment · Design, build, run
We test your water, then design, build and run the system that treats it. Process water, wastewater and reuse.
01Sound familiar?
We design from your real water analysis, and plan for your worst month, not your average one.
We recover water so you can use it again, and show you the running cost before you buy.
We design to your target numbers, then prove them on start-up day, in writing.
Packaged skids and containers are built in our shop and fit where you have room, even outside.
02What we do
One team from the first water test to the last filter change. Hire us for one step or all of them.
Water analysisKnow what’s in your water and what it takes to fix it.
We sample and test your water, so the design fits the water you actually have.
Each step sized to your flow and target quality, with the running cost up front.
Reverse osmosisEquipment made in our shop, tested before it ships.
Takes out sand, silt, iron and other solids.
Removes dissolved salts for high-purity water.
Cleans plant wastewater to meet your discharge limits.
Treats used water so it can run through the plant again.
Skids and containers, built ready to connect. Small footprint.
CommissioningKeep it on spec, every day after start-up.
We start it up, test it and prove it hits your numbers.
24/7 remote readings, with alerts before problems reach production.
Planned service visits and fast repairs.
Membranes, cartridges, media and chemicals, shipped when you need them.
03How we’d treat it
Different water needs different steps. Choose a job and a source to see how a typical system comes together, and where the waste goes.
1What do you need?
2Where does it come from?
Typical numbers for illustration. Your water analysis sets the real design.
04Will it fit?
Packaged and modular systems are built and tested in our shop, then set down on site. Here’s roughly how much room they take.
Compact skid
One frame with everything on it. Rolls in through a standard door.
05What we can take
Incoming water inside these ranges goes straight into a standard design. Outside them, we add a pretreatment step.
Contaminants we remove
06Industries
Every industry has its own water problem. These are the ones we solve most.
Product water, CIP water, high-strength wastewater
Boiler feed, cooling towers, blowdown reuse
Purified water, pretreatment for WFI
Ultrapure rinse water, fluoride removal
Rinse water recovery, metals removal
Process water, hard-to-treat effluent
Mine water, acid drainage, reuse
Oily wastewater, paint-line rinse
07Results
Evaporator condensate. COD 180 mg/L, TDS 95 mg/L. All of it went to drain.
Boiler make-up and CIP water. Conductivity under 10 µS/cm.
Ultrafiltration, reverse osmosis and UV on one packaged skid.
Plating rinse water. Nickel 38 mg/L, zinc 22 mg/L, pH 3.1.
Nickel under 0.5 mg/L at the sewer. Less sludge to haul.
pH control, metals precipitation, clarifier, filter press and polishing filter.
Well water. TDS 1,450 mg/L, silica 68 mg/L, hardness 520 mg/L.
Product water under 50 mg/L TDS. Zero floor space in the plant.
Softening, reverse osmosis and remineralization in a 40 ft container outside.
08Questions
What buyers ask us first. Ask us anything else, and an engineer will answer.
Almost certainly. Send us a recent water analysis and we’ll tell you what it takes. If something in your water needs a pilot test first, we’ll say so up front.
A standard lab report is a good start. No report yet? We can take the samples for you.
* for wastewater
Most systems run on their own. Your team checks readings once a day, or we watch them remotely. We visit on a set schedule to change cartridges, clean membranes and calibrate sensors. You get the plan and the yearly cost before you buy.
Every system makes some: backwash water, concentrate from reverse osmosis, or sludge. We show each waste stream in the design, with volumes and where it goes: to sewer, back into the process, or pressed into a solid cake for disposal.
Packaged units usually take 8 to 14 weeks from order to start-up. For larger custom plants, you get a full schedule with the proposal.
09Get started
Tell us about your water and your goal. An engineer replies within one business day.